With the proAIS2 software open on your PC/Laptop:
- Select the AIS device from the drop-down list at the top of the page.
- Click Connect.
- Enter your vessel’s details, including MMSI in the relevant fields.
- Select a Vessel Type appropriate for your vessel from the drop-down list.
- Click Write Configuration to save your configuration settings.
Setting the WiFi Configuration on proAIS2 software
- Under WiFi Tab General Settings;
- You can leave the default IP address or set a different IP address depending on your network.
- Next, set the Port number or leave the default in place.
- Under Access point mode;
- Give the SSID a name or leave it as default
- Click Write Configuration to save your configuration settings
Connecting iNavX to your B360 Transceiver
Go to the device home screen
Select "Settings" > "Wi-Fi” > Set "Wi-Fi" to "ON” > Select "AIS Class B or SSID Name you set in ProAis2".
Launch iNavX
- Select Instrumentsfrom the bottom of the screen
- At the top left-hand side of the screen select TCP/IP
- Enter the same Host (IP address) as set on ProAIS2 software e.g "10.0.1.2"
- Enter Port number as set on ProAIS2 software e.g "2114"
- Set "Location Services" to "ON”. Alternatively, you can enable position output from the B360 by ticking the x next to RMC- Recommended Minimum Data under the configuration tab.
- Enable "Link"