Panel mounting the X100
Panel mounting is a great solution for people that want to fix the X100 in place while having open access to the rear of the radio, via a removable panel or an access hatch. Before mounting, click here to check that the area selected meets the requirements.
Use the X100 panel mount template (included in the box) to measure and mark the installation location, then use a suitable tool to cut the hole for the X100.
Place the O-ring between the front panel of the X100 and the installation surface.
Pull the VHF and GPS antenna cables through the hole cut in step 1 and connect the cables to the correct ports on the back of the X100, click see here if you're not sure which ports are the correct ones.
Insert the X100 into the slot cut in step 1.
-
Using the appropriate tool, attach the panel brackets to the sides of the X100. Tighten the bracket nuts until the X100 is securely in place. So even in rough seas the X100 stays in place.