Mounting the X100

Everyone has a unique style, so the device can be mounted in various ways to suit your preferences.

Securely mount the X100 using the provided tools and fixings, making sure it's attached to a suitable surface where the screen is clearly visible during use.

Mounting options

Overhead (bracket)

Table top (bracket)

Panel mount

	INFORMATION
	Always leave enough space behind the X100 for proper airflow and room for cables. Also, ensure the screen is tilted slightly to reduce glare.

X100 bracket mounting

Bracket mounting is a great solution for people that want to fix the X100 in place while having open access to the rear of the radio.

Before mounting, click here to check that the area selected meets the requirements.

Place your bracket onto the mounting surface and use a pencil to mark the screw holes. Make sure that the bracket is in the correct location before you mark the holes.
When you are happy with the location, drill the holes in the mounting surface using an appropriate drill bit.
Mount the bracket onto the mounting surface using the 2x No.8 x 38mm Pozi countersunk head stainless steel screws, ensure that the screws are tightened well.
Connect the VHF and GPS antenna cables to the correct ports in the back of the X100, click here for more information.
Assemble the X100 onto the mounting bracket using the 2x mounting knobs.

Fist-mic holster mounting

Even though the fist-mic is connected to the X100 by cable, you don’t want it swinging loose while your vessel is moving. Install it close enough to the X100 so it's always easily accessible.

Make sure the holster is installed in a flat, clear area with enough space around it so you can easily insert and remove the fist-mic.
Use the fist-mic bracket or the template to mark the screw hole positions on the mounting surface making sure the substrate behind the intended location is solid enough to the fist- mic securely and robustly.
Drill two holes for the mounting fixings using a suitable drill bit. Make sure there is nothing behind the mounting surface before drilling.
Use the 2 No. 8 x 38mm Pozi countersunk stainless steel screws to secure the holster to the mounting surface.
And finally, slot the fist-mic into the holster.